Back to Driver Training

Loading and unloading

Loading procedure

Set up, load, clear the hose, and complete the ticket.

Wear safety glasses and all other company- and site-required PPE. During loading and unloading, remain outside the cab at the valves and monitor the transfer. Do not sit in the truck while fluid is being transferred. Follow the loading sequence for the equipment covered in Bell's source procedure. PTO means power take-off. This guide preserves the source's equipment terms.

Set up and begin loading

  1. Turn on the PTO switch. Use the On and Up buttons on the steering wheel to increase the engine RPM.
  2. Place the cone and wheel chock, set the PTO to forward vacuum, and connect the ground cable.
  3. Read the tank level from the monitor or strap the tank.
  4. Open the bleed valve in the Getty box. Remove the cap, connect the hose, and secure it with the strap or clip. Close the bleed valve.
  5. Open the trailer valve to the hose and close the PTO valve.
  6. Open the tank valve or valves. Check that fluid is flowing and inspect for leaks.
  7. Continually monitor the Getty box and sight glass.

Finish loading and clear the hose

  1. Close the valve to the tank. Bleed the line if there is a bleeder on the pipe.
  2. Open the Getty box bleed valve to draw the remaining water from the Getty box and hose.
  3. Close the trailer valve to the hose.
  4. Disconnect the hose. Cap the flow line and close the bleeder.
  5. Place the hose end in the Getty box. Open the trailer valve for 2–5 seconds to draw up the remaining fluid.
  6. Close the trailer valve to the hose and open the PTO valve to release pressure.
  7. Cap the hose and return it to the truck.

Secure the equipment and complete the ticket

  1. Record the bottom tank level. The source allows the PTO pump to be shut off before this measurement.
  2. Stow the ground cable, wheel chock, and cone.
  3. Inside the truck, turn off the PTO pump and return the engine RPM to normal.
  4. Complete the loading ticket in the app, print it, and leave it in the mailbox or shack.
  5. When driving loaded, keep the pusher and tag axles down.
View the original reference sheet Loading procedure — original training reference sheet

Select the image to open it at full size.

Download original

Source: Erik Isaacson · Bell Training · Loading Written Procedures.jpeg