Back to Driver Training

Loading and unloading

Unloading and sucking back the hose

Unload the trailer and use suction to clear the hose.

Wear safety glasses and all other company- and site-required PPE. During loading and unloading, remain outside the cab at the valves and monitor the transfer. Do not sit in the truck while fluid is being transferred. Unload the trailer, then switch back to suction to clear the hose.

Set up and unload

  1. Turn on the PTO switch. Use the On and Up buttons on the steering wheel to increase the engine RPM.
  2. Place the cone and wheel chock, set the PTO to reverse vacuum, and connect the ground cable.
  3. Open the bleed valve in the Getty box. Remove the cap, connect the hose, and secure it with the strap or clip. Close the bleed valve.
  4. Open the valve behind the Getty box. Some disposal sites use a different procedure.
  5. Open the trailer valve to the hose and close the PTO valve to build air pressure.
  6. Watch the pressure gauge and confirm fluid flow through the sight glass. The source describes flow usually beginning around 10–15 psi; it does not state a maximum pressure.
  7. Continually monitor the Getty box and sight glass for leaks.
  8. After unloading 50 barrels, lower the air bags.

Switch back to suction

  1. When the trailer is empty, close the valve behind the Getty box.
  2. Open the PTO valve to release pressure. Wait until the gauge reads around 0 psi, then set the PTO to forward vacuum.
  3. Close the PTO valve to begin building suction.
  4. At around 0 psi, open the Getty box bleeder valve to check for suction. Draw up fluid from the box. The source then directs the driver to disconnect the hose and draw the hose empty.
  5. Cap the Getty box flow line, close the bleeder valve, and close the Getty box.
  6. Close the trailer valve to the hose, then open the PTO valve to release pressure.

Clean up and finish

  1. Return the hose to its tray and stow the ground cable, wheel chock, and cone. Raise the air bags.
  2. Inside the truck, turn off the PTO pump, return the engine RPM to normal, and lift the pusher axle.
  3. Complete the unloading ticket in the app, print it, and leave it in the mailbox or shack.
View the original reference sheet Unloading and sucking back the hose — original training reference sheet

Select the image to open it at full size.

Download original

Source: Erik Isaacson · Bell Training · Unloading Procedure, Sucking Back Hose.jpg